Storage drives read and write data. This lesson helps you identify the three classic drives found in a computer and recognise their main parts.
Hard disk drive (HDD)
- Platters: round magnetic disks that hold the data
- Spindle and motor: spin the platters at high speed
- Read/write heads: read and write data on the platters
- Actuator arm: moves the heads across the platters
- Controller board: manages the data and connects to the computer
- Connectors: a data port (SATA or older IDE) and a power port
Floppy disk drive (FDD)
The floppy drive reads small removable magnetic disks of 1.44 MB. It is now mostly found in older machines and training labs. Its parts are the disk slot, the read/write head, the motor and a 34-pin data cable.
CD or DVD drive (CDD)
- Tray or loader: holds the disc
- Spindle motor: spins the disc
- Laser and lens assembly: reads the pits on the disc
- Sled motor: moves the laser across the disc
- Connectors: data (SATA or IDE) and power
Interface comparison
| Drive | Data connector | Typical use |
| HDD | SATA (older: IDE) | Operating system and files |
| FDD | 34-pin floppy cable | Small legacy files |
| CD/DVD | SATA (older: IDE) | Software discs and media |
Practical identification
- Switch off and open the cabinet safely.
- Find each drive and read the label on its top.
- Identify the data and power connectors.
- Note the model, capacity and interface of each drive.
- Record your findings in a table.
